Guide :Saws : G10SR3 4" Angle Grinder 6 Amp

Grinders power question

What amp do I need?

Research, Knowledge and Information :


Grinders in Cordless Handheld Power Tools - ShopYourWay


Grinders / Questions. Grinders in Cordless Handheld Power Tools 61 ... Ask a question. what is the difference in Milwaukee M-18 grinder compared to M-28 ?
Read More At : www.shopyourway.com...

Grinders and Metalworking | Bosch Power Tools


Grinders and Metalworking | Bosch Power Tools ... Grinders and Metalworking; Hammers; ... Have a service related question?
Read More At : www.boschtools.com...

Grinder questions - Home-Barista.com


As a second question, is there something special about the Compak E5 as it has a motor with three times the power of grinders with comparable burr size.
Read More At : www.home-barista.com...

GWS18V-50 | 18V 5 In. Angle Grinder (Bare Tool) | Bosch Power ...


Power Tools; Grinders and Metalworking; Angle Grinders; GWS18V-50; GWS18V-50. 18V 5 In. ... Have a service related question?
Read More At : www.boschtools.com...

Stump Grinder | 16.50 ft-lb Premier | DR Power Equipment


The top-of-the-line Pro-XL Stump Grinder ... Thanks for your interest and question ... http://www.drpower.com/power-equipment/stump-grinders ...
Read More At : www.drpower.com...

Angle Grinders | Genesis Power Tools


Genesis Power Tools > Handheld > Angle Grinders. Angle Grinders. 4 1/2" Angle Grinder. Contact Us. ... Click here to ask us a question about one of our products.
Read More At : www.genesispowertools.com...

Stump Grinder Tow Kit | DR Power Equipment


Our tow kit lets you hitch your DR Stump Grinder to an ATV, UTV, or riding mower with either a pin-hitch or ball hitch. It can be installed on our 8.34 Prem
Read More At : www.drpower.com...

Grinders - Metalworking Tools - Power Tools - Save on Top ...


Grinders from DeWALT, Milwaukee, Makita and other top tool brands. Low prices, free fast shipping, knowledgeable staff, secure shopping.
Read More At : www.toolnut.com...

Dosko Stump Grinders - Power Equipment Direct - The Power to ...


Dosko Stump Grinder Store. Compare Top Brand Dosko Stump Grinders. Power Equipment Direct specializes in Dosko Tree Stump Cutter, Dosko Stump Cutter and Dosko Tree ...
Read More At : www.powerequipmentdirect.com...

The daily grind: Test your knowledge on grinder safety


The daily grind: Test your knowledge ... “Because abrasive wheel grinders are everyday equipment ... “and we want all workers to have the power to work safely and ...
Read More At : reliableplant.com...

Suggested Questions And Answer :


Grinders power question


Consider a high amp motor if you want enough power (torque) for heavy use without stalling or slowing
Read More At : G10SR3 4" Angle Grinder 6 Amp...

How do i change carbons - Hitachi G10SR3 4" Angle Grinder 6 Amp


There should be either one or two access screws(usually black in color,plastic looking) on the body of the grinder. remove screw cap,holddown spring,and remainder of 'brush'/carbon. Reverse steps for installation.
Read More At : G10SR3 4" Angle Grinder 6 Amp...

Need help with my angle grinder. It quit working and the switch was bad . I replaced it . Not sure on where all the wires go. I have blk to blk and wht to wht. The wire coming from the electronic pack ( blk wire is on the switch with the other blk wire coming threw the switch from power. a red light flashes on the electronic pack when I trip the switch. It will not run or try to run. Is the electronic pack bad??? Do you have an electrical drawing and what do you think is wrong with it. Help. Michael Anderson


No its the brushes it was never the switch its runs at 9000 rpms the brushes ware out fast but this is a good tool save it
Read More At : 469 WE14150Q 01451 6" GRINDER 120 AMP 9000 RPM QUICK CHANGE......

I have a Bosch 1375A that I use for many diffrent small work at home. Today I was cutting ceramic with a diamond head wheel. Something I am used to do. After a cut, the grinder didn't want to power-on again. I cleaned it up with air can. Still doesn't want to start. Is there any fuse or reset on this type of equipment ?


Check the fuze in the plug Check the wall socket is working Remove the motor bushings and check them for wear - motor busining should be behind plastic screws located on either side of the motor.If there is/was a smell of burining out of the motor you may have blown it. This is usually caused by holding the air vents when using it. Also when you try to turn it on does it make any noise at all? even a quiet buzz sound?
Read More At : 1375A 4 - 1/2" Small Angle Grinder - 6 Amp...

Not getting enough power?


Brushes or bearings worn out
Read More At : W6-115 606111420 4 1/2" Angle Grinder...

Fixing bad motors in dewalt angle grinders power tools


It would be much better if you bought a new one because it would be cheaper
Read More At : DW824 5" Electric Angle Grinder...

Angle grinder head is worn how can i fix it - Black & Decker Black Decker Decker G750 4 12" Angle Grinder 6 Amp


Http://www.ereplacementparts.com/search_result.phpWhy not replace the worn part?It would be safer.
Read More At : Black Decker Decker G750 4 12" Angle Grinder 6 Amp...

Makita Angle Grinder not working


Check inside for any loose connections plus check the brushes. if like you say it is smoking it could be a trip to the wheelie bin for that one.
Read More At : Angle Grinder 4.5" 9524NBX...

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
next Question || Previos Question
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.powertoolz.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0369 seconds