Guide :Saws : 10" Dual Slide Compound Miter Saw with Light LS1013F

Brand new miter saw/ran for 10 hours power was not consistent, then nothing

This is a makita sliding dual mitersaw # LS1013, that I bought a few years ago (brand new) as a back up. I never used it under it's warranty. Shipped it to Hawaii and repair guy here says it needs a new motor. Has this been a problem with these saws, or do I have a lemon? I've been a Makita guy for ever and have bought many of your tools, I recently bought my fifth power planer over my carpentry carrier and I'm pretty disappointed with this saw.

Research, Knowledge and Information :


MAKITA - Cordless and Corded Power Tools, Power Equipment ...


... crosscut and vertical cutting height compared to a 10" miter saw. ... a 10" saw typically has less blade run out and ... charging a brand new battery to a full ...
Read More At : www.makitatools.com...

Ryobi One+One Brushless 36V-Equivalent Dual-Bevel Sliding ...


May 25, 2017 · Best Cordless Power Tool Brand; Best Cordless Drills (New ... just announced a 10″ dual-bevel sliding miter saw as ... have had nothing since then, ...
Read More At : toolguyd.com...

The NEW Bosch Axial Glide Miter Saw! | THISisCarpentry


Then I fabricated a simple plastic sheeting tent around the saw. I installed a brand new ... The NEW Bosch Axial Glide Miter Saw! ... saw. For 10 years I ran ...
Read More At : www.thisiscarpentry.com...

Bosch GCM12SD 12 in. Dual-Bevel Glide Miter Saw


The innovative Bosch Bosch GCM12SD 12 in. Dual-Bevel Glide Miter Saw delivers durable precision, ... With this new saw, ... Normally I run the power tools, ...
Read More At : www.cpooutlets.com...

Kobalt 10" Sliding Compound Miter Saw Review - One Project Closer


Kobalt 10″ Sliding Compound Miter Saw ... opened the box. DONE. now you have a brand new saw for 80 bucks and the ... I then checked the miter angles with a ...
Read More At : www.oneprojectcloser.com...

Bosch CM10GD 10-Inch Dual Bevel Glide Miter Saw, 15-Amp ...


Bosch CM10GD 10-Inch Dual Bevel Glide Miter Saw, 15-Amp - Power Miter Saws ... It has run-out from hell ... I haven't tried to cut anything yet but my brand new ...

Makita 10'' Dual Slide Compound Miter Saw | Things I could ...


Makita 10'' Dual Slide Compound Miter Saw. ... with a brand new Dewalt sliding miter saw and wanted to ... Power Tools 10 in. Sliding Compound Miter Saw 15 Amp ...
Read More At : www.pinterest.com...

Hitachi C10FCE2 10-Inch Compound Miter Saw by Hitachi, http ...


Hitachi C10FCE2 10-Inch Compound Miter Saw by ... A Whole Slew of Power Tool Tutorials: 19 hours of research into ... nothing like finding out a slick brand new ...
Read More At : www.pinterest.com...

Suggested Questions And Answer :


Brand new miter saw/ran for 10 hours power was not consistent, then nothing


What part of the motor has blown? There is the armature and field coil and they won't always need replacing at the same time. There are brushes as-well, but as they are quite cheap I'm guessing you have been quoted on one or both of the motor parts to be replaced. Have you asked the repair guys for a report. They should be able to suggest a reason for what has blown and why by looking at the faulty parts. Although most manufacturers and service agents have discretion over warranty claims, if your machine is more than a few months over htere is almost definately noting you can do on the warranty side of things.
Read More At : 10" Dual Slide Compound Miter Saw with Light LS1013F...

Makita miter saw has no power - Makita 10" Dual Slide Compound Miter Saw with Light LS1013F


Disconnect it from the wall outlet. Use a VOM set to continuity (i.e ohms) connect one lead to each of the power cords. Depress the start switch. If switch and circuits are good you should get either a low reading or just 0.0. IF you get no reading or really high reading the unit has an internal fault and more troubleshooting will have to be done.
Read More At : 10" Dual Slide Compound Miter Saw with Light LS1013F...

Recalibrating the angles - Makita 10" Dual Slide Compound Miter Saw with Light LS1013F


Look on top of fencesee 4 holes loosen 4 bolts (probably hex wrench) and fence will loosen alsoframing square against loose fence and lowered blade (to calibrate square)tighten fence,... square to blade
Read More At : 10" Dual Slide Compound Miter Saw with Light LS1013F...

Makita LS1013 compound saw wont slide,instruction manual no help. I have nevr operated a miter saw before so any help would be appreciated


You may find, you have a lock, button, that needs to be held in, before you can drop the saw to cut.
Read More At : 10" Dual Slide Compound Miter Saw with Light LS1013F...

Frozen slide mechanism


Lubricate it with graphite powder OR silicone spray lube but not both
Read More At : 10" Dual Slide Compound Miter Saw with Light LS1013F...

How do I remove the threaded rod from beneath the turn table of a Mikita LS1013 Slide Compound Mitre Saw ? I have removed the two black turning/tightning handles but cannot see how the rod is removed.


If you removed the handle from the rod you would need to put a pair of pliers on it gently and remove it. or if you turn it upside down and remove the tube from sliding mechanism you can grip the rod from there and unscrew
Read More At : 10" Dual Slide Compound Miter Saw with Light LS1013F...

Slide mechanism jammed


Try squirting WD 40 all over the rails and into the bearings...Your bearings could have rusted in place and won't turn. Or maybe one is rusted and the other turns a bit...You could use a good pair of vice grips to remove that stripped screw.if that will give you better access..I haven't ever seen one jammed up like that though...Otherwise, you might look up the parts diagram and see what you're getting into there, if there's anything that could have broken off inside that's hanging up..link here.I hope this information allows you to resolve this issue. If you need further assistance, please post back with a comment to this thread. If I've managed to answer your question or solve a problem, please take just a moment to rate this post....thanks!
Read More At : 10" Dual Slide Compound Miter Saw with Light LS1013F...

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
next Question || Previos Question
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.powertoolz.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0708 seconds