Guide :Saws : Saws

Batterys will not hold charge

I brought a three wheel scooter for my wife and the next day i had to buy two new batterys for it as the other ones did not hold their charge but when i put the new ones in and charged them it still will not charge as on the scooter there are three lights on it they are red yellow and green the green light tells you that the scooter is fully charged but the green will not light up and it as not blown as if i put it into neutral all the lights will flash and i charged it overnight and took it out in the morning it whent flat in about 5 min of putting the key in so you see it as had two new batt

Research, Knowledge and Information :


How to Fix a Laptop That Is Not Charging: 15 Steps (with ...


How to Fix a Laptop That Is Not Charging. ... Shut down the computer and disconnect the power cord. Remove the battery. Press and hold the power button for five seconds.
Read More At : www.wikihow.com...

Battery will not hold a charge Inspection Service & Cost ...


Battery will not hold a charge Inspection costs between $70-$80 on average. Get an instant estimate for your car. Book a mobile mechanic, backed by warranty. Service ...
Read More At : www.yourmechanic.com...

Battery not holding charge | Verizon Community


Ever since my last upgrade the battery is not holding it's charge very well. I've disabled the locator. Anybody else having problems? Any suggestions?
Read More At : community.verizonwireless.com...

HP Notebook PCs - Battery Does Not Power Notebook or Hold a ...


If your notebook computer battery does not power the notebook or will not hold a charge, troubleshoot the battery to see if it needs to be replaced.
Read More At : support.hp.com...

How to Fix a Car Battery That Won't Hold a Charge


How to Fix a Car Battery That Won't Hold a Charge ... check Using a trickle charger is the best way to fix a battery that will not hold a charge. A battery that has ...
Read More At : itstillruns.com...

Identify and Troubleshoot Automotive Charging System Problems


Solution #2: If the battery won’t hold its charge and your engine stalls out, ... The battery ins not holding the charge even though it is new.
Read More At : www.onallcylinders.com...

Battery not holding charge - Fitbit Community


Hi all, I got myself a Fitbit one for christmas with a voucher, and after having to return the first one (the charger was missing), I now have the
Read More At : community.fitbit.com...

Common Car Battery Problems and How to Fix Them - Autos.com


In the paragraphs below, you will be presented with a number of common car battery problems and their solutions. ... but the battery still won’t hold a charge, ...
Read More At : www.autos.com...

My Battery Won't Hold a Charge - YouTube


Jun 07, 2011 · http://www.geniuschargers.com There are many reasons why a battery might not be able to keep or hold charge. This video provides you with some important ...

Suggested Questions And Answer :


Brand new Ryobi circular saw. The blade is in, the battery is fully charged and works with the other products, but the circular saw is jamming. It is twitching a bit, but not reaching a full spin at all. I hold the lock and make sure the guard is up, but still, nothing...


Return to store for replacement.
Read More At : 12V 4pc Li-ion Combo Kit...

Batterys will not hold charge


Hi kevinsharpe8;Right off the top of my head I would suspect the charging circuit. The way to check this is to measure the voltage at the batteries while they are on charge. The voltage reading when they are supposed to be charging should be higher that what you would read at the batteries when they are not charging.These charging circuits are not complicated and any electrician type should be able to trouble shoot the circuit and find the problemHope this helps Good Luck Loringh PS Please leave a rating if appropriate thanks
Read More At : Saws...

My Makita DSS610 18v cordless circular saw stopped working mid cut. I changed the battery to another, fully charged, one but still nothing. Tried again next day, with both batteries, still nothing.


Http://www.mtmc.co.uk/Makita-DSS610-Spare-Parts__p-75682.aspx maybe the autostop protection in one of the carbon brushes has been activated turn position 13 loose with a screwdriver its easy to remove and replace look this link for the position numbers . Makita DSS610 Spare Parts
Read More At : Makita...

Plug battery in and lights don't go on


The battery is failing and is starting to degrade. If you can't get it to take a full charge, you might want to mark it for use in your flashlight only, but eventually, the battery won't take any charge and you'll have to replace it. The good news is the the Ryobi battery tools have the lowest cost of rechargeable batteries in the marketplace. I believe you can purchase a 2 pack at Home Depot for under $40.00 which is very inexpensive for two (2) Ni-Cad batteries. If you battery is from a new tool set, just simply contact Ryobi Customer Service and they'll address the problem with a replacement. If the batteries are ones you've been using for awhile, then go for the replacement. NiCad batteries should be used until the tool slows down to the point where you can't use it. Then remove the battery from the tool and allow it to cool down for about 15-20 minutes before placing it in the charger. This will provide the maximum working life for your batteries. When you use a battery powered tool, the battery gets warm/hot as it discharges, and then it gets heated up during the recharging process, so letting it cool down after using it, will prolong the useful life of that battery. Hope you find this Very Helpful and best regards!
Read More At : 3-piece 18V Drill / Circular Saw / Light Combo Tool Sets...

Ryobi 18v lithium battery won't charge


Sound to me like you have a bad battery, a lot of ryobi batterys don't last like they should i have had the same problem, but my battery was less than a year old and i took it back and they give me a new one.
Read More At : 3-piece 18V Drill / Circular Saw / Light Combo Tool Sets...

Battery charge problems Ryobi 18v


Solution is two fold. Will try the freeze and re charge approach today and do this a few times. The long term soluiton is to purchase two Lithium batteries and a duel chemical charger. Expensive solution but seems it will work.
Read More At : 3-piece 18V Drill / Circular Saw / Light Combo Tool Sets...

Bosch CCS180 18V lithium cordless circular saw. Starts first time only when battery put in place. Won't start again until battery removed and reinserted. Not recharged again, just reinserted. Then starts fine but won't start again until battery again removed and reinstalled. Same for all three Bosch FatPac batteries I've tried. All remained charged. Is there some safety cut off button or something?


Hi ramzemail,Welcome to fixya!It sounds like the wire connection where you insert the battery is loose. So, when you give the battery a shove in, the connection tightens, then the vibration from use loosens it again. You would have to take the hand grip piece apart until you can see the wiring and check the connections. Here is a diagram to help you disassemble the unit: http://www.ereplacementparts.com/images/bosch/CCS180K_%283601F6H010%29.pdf Copy and paste this entire address into your browser and the diagram for CCS180K will open for you. Should your model be the CCS180B, use this address: http://www.ereplacementparts.com/bosch-ccs180b-3601f6h010-18v-litheontrade-612-circular-saw-parts-c-128_1138_15136.html The battery area is the same for both but, in case you ever need parts, I'll give you both.Good luck. Hope this helps. Please place a vote when you accept this solution. Thanks,Handie Andie
Read More At : 18v Litheon 612" Circular Saw Ccs180...

Why doesn't the laser marker work on my Makita mitre saw?


Contact Makita, it may be defective , or they can troubleshoot. You can check on youtube.com for a possible fix also.
Read More At : 10" Miter Saw LS1030N...

Ryobi lithium batteries won't take charge


For others with the same problem (flashing red light won't go off)...make sure you FIRMLY PUSH the battery down onto the charger and engage the latches. Simply resting the battery on the charger will not work.
Read More At : 3-piece 18V Drill / Circular Saw / Light Combo Tool Sets...

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
next Question || Previos Question
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.powertoolz.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0523 seconds