Back in 1995 or 1996 I bought a Craftsman table saw Model 137.221940, which has continued to run very well, except that the blade has grown slightly out of line with the miter gage track. I long ago lost my owners manual and now don't know which bolts to unfasten the table top to get at adjusting the trunions. Try as I might, I can't seem to find a replacement manual for sale. Help!
MITER GAUGE ADJUSTMENT (FIG, O)
1. Make sure that the mitergauge will slide freely
through both table grooves.
2. Loosen the lock knob (1). Set pointer (2) at the 90°
mark on the scale.
3. Using a piece of scrap wood, make a 90° cut. Then
check the cut piece to see if it was cut at 90°. If not
90° , continue to adjust the miter gauge body (3) until
the wood piece is cut at 90°.
4. When a 90° degree cut has been made, loosen the
pointer screw (4) and set on the 90° scale mark.
RIP FENCE ADJUSTMENT (FIG. P)
To avoid injury from an accidental start, make sure the
switch is in the "OFF" position and the plug is not
connected to the power source outlet.
1. The fence (1) is moved by lifting up on the handle (2)
and sliding the fence to the desired location. Pushing
down on the handle (2) locks the fence in position.
2. Position the fence on the right side of the table, and
along one edge of the miter gauge grooves.
3. Lock the fence handle (2). The fence should be
parallel with the miter gauge groove.
4. If adjustment is needed to make the fence parallel
to the groove, do the following:
5. Loosen the two screws (3) and lift up on the handle (2).
6. Hold the fence bracket (4) firmly against the front of
the saw table. Move the far end of the fence until it
is parallel with the miter gauge groove.
7. Tighten both screws (3) and push the handle (2)
8. If fence is loose when the handle is in the locked
(downward) position, do the following.
9. Move the handle (2) upward and turn the adjusting
screw (5) clockwise until the rear clamp is snug.
Do not turn the adjusting screw (5) more than
1/4 turn at a lime.
10. Over-tightening the adjusting screw (5) will cause
the fence to come out of alignment.
Also here is the manual if you would like
Good luck Read More At : Craftsman...